Welcome to the
Bearing System Help Section
What is a
bearing yo-yo (also nicknamed a roller bearing or ball bearing yo-yo)?
First, lets start off with what a bearing is. Simply put for our purposes, a
bearing is a ring shaped track containing tiny steel balls throughout that roll
within it. This causes bearings to be super long spinning mechanisms and it
allows for what we call high performance yo-yo play.
The bearing yo-yos are great advanced level players with some experience yoing. Unlike the auto-return yo-yos like the Brain, the bearing yo-yos will not return automatically. Instead they rely on the player to manually cause return by inducing a flick of the wrist or jerking motion upward.
Ok, Now that you know how the yo-yo works, lets see if we can solve what's causing your grief. Below are some common problems experienced with these types of yo-yos and with them some solutions.
My yo-yo won't
return!
Not good, but here are some reasons this may be - from the most obvious to the
more remote.
1. Remember the bearing
yo-yo is not an auto return yo-yo, so you must give the yo-yo enough energy in
the throw to allow it to return. So, if you're just dropping it down, try giving
it a harder throw before trying to get it to return.
2. One of the main reasons a bearing yo-yo will not return has to do with the
stringing. Remember the instructions? If you do, you'll recall that the
transaxle yo-yos require the
single loop method of
stringing.
3. Lubricant - when the yo-yos leave the factory they have a small amount of
lubricant on their axles. This lubricant allows for a more responsive yo-yo.
After long use, this lubricant needs to be replenished. To solve this problem,
place a small drop of Brain Lube on the axle (you must take the yo-yo apart to
do this). If you don't have Brain Lube you may substitute with a small drop of
mineral oil. Please Note: DO NOT use any type of spray oils, they are harmful to
the yo-yo and it's plastic. SPECIAL NOTE: When lubricating the bearing yo-yo
take special care in making sure that you do not lose the bearing spacers inside
the yo-yo. Also, make sure you place these spacers properly back on the axle.
There should be one spacer on each side of the bearing and the smooth side of
the spacer should face the plastic of the yo-yo.
4. Frayed or worn string - sometimes bearing yo-yos will have a hard time
returning if the string is worn down and dirty. In this case, try putting a new
string on it - but remember the single loop method when you do!
My yo-yo won't
sleep!
1. Back to the throw - just like the yo-yo won't return unless you throw it hard
enough, it won't sleep for the same reason. Remember, in order to get the yo-yo
to sleep you must get the yo-yo to spin properly and the only way that happens
is to give it a hard enough downward throw.
2. String thing - perhaps the string is knotted or pinched around the axle.
You'll know this is the case if the yo-yo snaps back rapidly to your hand. If
so, take the yo-yo apart, remove the string or knot, put the yo-yo back together
and then restring it using the single loop method.
3. Inside parts - Ok, if you think the yo-yo is strung properly and it sleeps
but not very well, you must check to see if the spacers are in correctly. A
misplaced spacer will misalign the yo-yo and cause a lot of friction. Make sure
the smooth side of each spacer faces the plastic and the grooves face the
bearing.
My yo-yo is making some loud noises!
This is almost always due to a lubricant issue. To correct it, just put a drop of Brain Lube on the axle - and bye, bye noise!
Page contents copyright Yomega http://www.yomega.com/help/support_bearing.htm
